South East London

This client in Chislehurst wanted to create a better first impression as their front Victorian tiled step looked tired and had been damaged by long term settlement in the sub floor. They ideally wanted to keep the original tiling but thought it would have to be replaced. The problem was that one section of the base had dropped and the tiling had cracked either side of this.

After visiting the property, I told the client that it could be repaired with matching reproduction tiles and fully restored. My client was happy with this suggestion, and they agreed to go ahead with my quote on that basis.

Repairing a Victorian Tiled Path and Step

Our workload has been busy this year so I returned as soon as I could and started by carefully lifting the tiles from the dropped section and all the cracked tiles that had been affected. Before retiling I had to underpin the original base and raise the level with new concrete. Once this was done, I left the property for a few days so the new concrete base could cure fully.

When I returned to the job, I set about fixing the replacement reproduction tiles in place laying them down in the same pattern as before, again these needed time for the adhesive to set so I left the property once completed.

Restorative Cleaning of Victorian Tiles

I returned again a few days later to clean and seal the tiles. I first used Tile Doctor Remove and Go to remove any ground in dirt and old sealers that may be on the original tiles. As these tiles were outside and open to the elements, I needed to remove some blackening from the tiles and used Tile Doctor Patio and Brick Driveway Cleaner to get that off. I put this on the tiles and let it dwell for a while, adding water to it to keep the tiles wet. It was a small area so to help lift the dirt out of the tile I scrubbed the tiles by hand. Once done the whole area was rinsed with more water and the soil extracted with a wet vacuum.

The next step was to bring up the appearance of the tiles and remove further dirt with the application of a 100 and then 200-grit milling pad. These pads are applied with water for lubrication and do a great job of deep cleaning the tiles and hone up the face of the tile to ease the sealing process. It was a small area, and the weather was good so it wasn’t too long before I could move onto sealing.

Sealing a Victorian Tiled Path and Step

When the tiles were dry, I applied two coats of Tile Doctor Colour Grow and then once this had dried, I applied a coat of Tile Doctor Stone oil. Both these sealers are impregnators, which soak into the pores of the tile to enhance the appearance and natural colours of the tiles.

It took a half few days to fully restore the path, fortunately Chislehurst is very close to my base in Bromley and so I was able to do some other work in between. The step looked new afterwards and my client was very impressed with the completed job.

Professional Restoration of a Victorian Tiled Step in South East London